Print
Chemical Datasheet
Chemical Identifiers
CAS Number |
UN/NA Number |
DOT Hazard Label |
USCG CHRIS Code |
|
none
|
data unavailable
|
|
NIOSH Pocket Guide |
International Chem Safety Card |
none
|
|
NFPA 704
General Description
Colorless liquid. May float or sink in water. (USCG, 1999)
Hazards
Reactivity Alerts
none
Air & Water Reactions
Insoluble in water.
Fire Hazard
This chemical is combustible. (NTP, 1992)
Health Hazard
No symptoms reported for any rate of exposure. (USCG, 1999)
Reactivity Profile
DIISODECYL PHTHALATE is an ester. Esters react with acids to liberate heat along with alcohols and acids. Strong oxidizing acids may cause a vigorous reaction that is sufficiently exothermic to ignite the reaction products. Heat is also generated by the interaction of esters with caustic solutions. Flammable hydrogen is generated by mixing esters with alkali metals and hydrides. Can generate electrostatic charges. [Handling 365bet娱乐 Safely 1980. p. 250].
Belongs to the Following Reactive Group(s)
- Esters, Sulfate Esters, Phosphate Esters, Thiophosphate Esters, and Borate Esters
Potentially Incompatible Absorbents
No information available.
Response Recommendations
Isolation and Evacuation
No information available.
Firefighting
Fire Extinguishing Agents Not to Be Used: Water may be ineffective.
Fire Extinguishing Agents: Dry chemical, foam, carbon dioxide (USCG, 1999)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you spill this chemical, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with alcohol followed by washing with a strong soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
STORAGE PRECAUTIONS: You should store this chemical under refrigerated temperatures and away from oxidizers, mineral acids and bases. (NTP, 1992)
Protective Clothing
Goggles or face shield; rubber gloves (USCG, 1999)
DuPont Tychem庐 Suit Fabrics
No information available.
First Aid
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.
INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
Physical Properties
Flash Point:
450掳F
(NTP, 1992)
Lower Explosive Limit (LEL):
0.2 %
at 508掳F
(USCG, 1999)
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature:
755掳F
(USCG, 1999)
Melting Point:
-58掳F
(NTP, 1992)
Vapor Pressure: data unavailable
Vapor Density (Relative to Air):
15.4
(NTP, 1992)
- Heavier than air; will sink
Specific Gravity:
0.967
at 68掳F
(USCG, 1999)
- Less dense than water; will float
Boiling Point:
482 to 495掳F
at 4 mmHg
(NTP, 1992)
Molecular Weight:
446.67
(NTP, 1992)
Water Solubility:
Insoluble
(NTP, 1992)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable
AEGLs (Acute Exposure Guideline Levels)
No AEGL information available.
ERPGs (Emergency Response Planning Guidelines)
No ERPG information available.
PACs (Protective Action Criteria)
No PAC information available.
Regulatory Information
EPA Consolidated List of Lists
No regulatory information available.
CISA Chemical Facility Anti-Terrorism Standards (CFATS)
No regulatory information available.
OSHA Process Safety Management (PSM) Standard List
No regulatory information available.
Alternate Chemical Names
- 1,2-BENZENEDICARBOXYLIC ACID, DIISODECYL ESTER
- BIS(8-METHYLNONYL)PHTHALATE
- BIS(ISODECYL) PHTHALATE
- DI-ISODECYL PHTHALATE
- DIDP
- DIDP (PLASTICIZER)
- DIISODECYL PHTHALATE
- HEXAPLAS DIDP
- ISODECYL ALCOHOL, PHTHALATE (2:1)
- ISODECYL PHTHALATE
- JAYFLEX DIDP
- PALATINOL Z
- PHTHALIC ACID, BIS (8-METHYL-NONYL) ESTER
- PHTHALIC ACID, DIISODECYL ESTER
- PLASTHALL DIDP
- PLASTICIZED DDP
- PX 120
- SICOL 184
- VESTINOL DZ